ESU 59626 LokPilot 5 DCC, 6-pin NEM651, Retail

ESU 59626 LokPilot 5 DCC, 6-pin NEM651, Retail Product Details

Description

The LokPilot 5 DCC is the "twin brother" of the LokPilot 5. The two share almost all features, but the LokPilot 5 DCC is a pure DCC decoder and cannot be used on analog AC systems. However, this sacrifice of flexibility is rewarded with a lower price.

Functions

Depending on the interface version, each LokPilot 5 DCC decoder offers at least 10 amplified function outputs with 250mA output current each. All important light functions are available. The brightness of each output can be set separately. The decoder is capable of automatic coupling and uncoupling for ROCO®, Krois® and Telex® couplings.

Motor control

The motor control of the LokPilot 5 DCC has again been fundamentally improved. A variably adjustable PWM clock frequency from 10kHz to 50kHz ensures super-quiet operation, especially with bell-type armature motors - the typical "humming" is a thing of the past. The load control can now also be adapted to difficult cases with up to 10 CVs. The unique "Autotune" function enables automatic tuning of the decoder to the motor. With up to 1.5A motor current, the LokPilot 5 DCC decoder provides enough power even for older motors.

Operational safety

If required, a PowerPack can be connected to the LokPilot 5 DCC to bridge dirty sections of track.

Protection

It goes without saying that all function outputs and the motor output are protected against overload. We want you to enjoy your decoder for as long as possible.

Features:

• ESU - LokPilot 5 DCC, 6-pin NEM651, Retail
• 6-pin NEM651
• Track gauge H0 ,0

Operating modes:

• NMRA/DCC with 14, 28 and 128 speed steps, DCC RailCom®
• DCC 2-digit and 4-digit addresses (short and long addresses)
• Analog DC voltage (can be switched off)
• Automatic detection of operating mode and DCC speed level setting
• Support for Lenz® LG100, Märklin®, Roco® braking sections and ZIMO® HLU commands
• Support for ABC braking mode and ABC shuttle train route
• False start bit / storage of operating states
• Shunting gear and acceleration and braking delay switchable by button

Speed controller part:

• 2.0 A continuous load capacity
• Connection of DC bell-type armature and AC motors (with permanent magnet)
• Silent, motor-friendly control with up to 50 kHz clock frequency
• Motor output protected against overload. 5th generation load control (can be switched off)

Function outputs:

• 10 amplified function outputs
• Version with 21MTC interface additionally 2 logic level outputs and 2 further logic level outputs instead of SUSI
• Version with PluX22 interface 2 logic level outputs instead of SUSI
• 250mA load capacity per amplified output
• Total current of all function outputs approx. 500mA. Outputs short-circuit proof
• Assignment of the function outputs freely selectable (function mapping)

Dimensions:

• 21.4mm x 15.5mm x 4.5mm