ESU 53900 Profi-Prüfstand für Decoder

In addition to a 6-pin interface according to NEM 651 and an 8-pin interface according to NEM 652, there is also a 21MTC interface according to NEM660, a PluX22 socket and the Next18 interface: No matter which decoder you have: Just plug in the decoder - done!

Locomotives without interface connectors can be contacted with single cable clamps.

A high quality bell armature motor with flywheel mass is used in conjunction with direction LEDs to control the motor output: So easy you control the slow speed characteristics and the synchronization of the decoder. An LED monitor informs you about the functions of the front and rear light output as well as the function outputs AUX1 to AUX6.

For testing LokSound decoders we have included a 20 mm speaker. You can choose whether the built-in speaker should be switched off or 100 Ohm or 16 Ohm - the test stand fits perfectly for every ESU decoder generation!

Two SUSI connectors allow direct testing of optional SUSI modules as well as forwarding to another board. The connection to the digital command station or the LokProgrammer is done either comfortably with the help of a removable, two-pole terminal block (same system as on the LokProgrammer or the ECoS) or with the help of two solder connections.

Features:

• Professional test bench
• 6-pole interface according to NEM 651
• 8-pin interface according to NEM 652
• 21MTC interface according to NEM660
• PluX22 socket
• Next18 interface
• 2 SUSI connectors

Specs:

• Gauge: H0
• Type: Accessories

Instruction manual / Safety instructions:

• Manual (1.7 MB)

Further links:

• Print View

CAUTION: Not suitable for children under 3 years. Danger of swallowing! Age recommendation from 14 years.