ESU 59212 LokPilot 5 Fx DCC/MM/SX, PluX22 NEM658

The LokPilot 5 Fx is a function decoder without motor output and thus perfectly suited for installation in control cars or function models. Because it speaks DCC with RailCom® as well as Motorola and Selectrix, it can be used with all common digital command stations. Its flexible function key assignment and the manifold light effects it shares with the other LokPilot 5 decoders from ESU. The LokPilot 5 Fx comes in three variants: In addition to the "classic" version with 8-pin NEM 652 wiring harness, a variant for the 21MTC interface and with PluX22 interface is also available.

Features:

• ESU - LokPilot 5 Fx DCC/MM/SX
• NMRA/DCC with 14, 28 and 128 speed steps, DCC RailCom®
• DCC 2-digit and 4-digit addresses (short and long addresses)
• Digital Motorola® (old and new), up to 255 addresses in Motorola® operation
• Selectrix® operation
• Analog DC voltage (can be switched off). Analog AC voltage (can be switched off)
• Automatic detection of operating mode and DCC speed step setting
• Support of Lenz® LG100, Märklin®, Roco® brake sections and ZIMO® HLU commands
• Support for ABC brake mode and ABC shuttle train route
• Wrong drive bit / storage of operating states
• Intelligent programming mode with Märklin® 6021®
• Shunting mode and acceleration and braking delay switchable by button
• 10 amplified function outputs
• Version with 21MTC interface additionally 2 logic level outputs as well as 2 further logic level outputs instead of SUSI
• Version with PluX22 interface 2 logic level outputs instead of SUSI
• 250mA load capacity per amplified output
• Total current of all function outputs approx. 1500mA. Outputs short circuit proof
• Assignment of function outputs freely selectable (function mapping)
• Dimensions: 16,5mm x 15,5mm x 4,5mm

Specs:

• Gauge: H0
• Type: Accessories

Further links:

• Print View

CAUTION: Not suitable for children under 3 years. Danger of swallowing! Age recommendation from 14 years.