Delicate yet practical to assemble
Design windows, railings and vehicle parts
Deliberately strengthen window mullions
A full-size mullion 40 millimetres wide becomes only about 0.33 millimetres wide in TT. Exact scaling is not always the best construction method. Compare slightly stronger struts and larger clear openings on a small window section. Keep the visible frame slim and, where needed, reinforce it on the hidden rear face.
Separate window frames make material selection and painting easier. Clear film can provide the glazing. Allow a supporting ledge and some assembly clearance so the pane is not under stress. Assess the appearance from normal layout viewing distance too; paint can alter tiny openings more than expected.
Railings and ladders need a sound structure
A tube with a full-size diameter of 30 millimetres would have a model diameter of just 0.25 millimetres. At this size, unsupported length, material and contact during installation matter particularly. Thicken vulnerable transitions, divide long railings into sections or combine printed posts with wire. Etched parts are another option for particularly fine, flat structures.
Place support contact points where they will later be hidden or easy to finish. Avoid applying leverage to thin bars when removing supports. A broken railing often calls for a design change; a smaller layer height alone will not eliminate the weak point.
Coupling pockets are functional parts
For interchangeable coupling heads in TT and N, the MOROP recommendation NEM 355 (German PDF) describes the coupling pocket; NEM 359 is also relevant for TT. Simply scaling down an H0 pocket does not reproduce this geometry. Mounting height, guidance and space for movement must also suit the vehicle.
First test a custom part with the intended coupling head, then when pulling and pushing through the tightest curves and points you use. Check free movement, return to centre and repeated loads. Printed spring tabs and snap-fit lugs may behave differently from production parts because of their material. For a first conversion, a printed bracket with a suitable ready-made pocket is often easier to assess.
A few features make all the difference on figures
An adult TT figure is approximately one and a half centimetres tall. The face, hands and foot positions must remain recognisable within this small space. Resin often offers better possibilities than FDM here. Compact poses and fewer freestanding details make handling easier. Ready-made figures can complement a custom-printed scene.