Uhlenbrock 77500 decoder Spur I, Multi, DC, Regelung, SUSi

77500 mainline decoder with SUSI interface

For operation with DCC systems, such as Uhlenbrock, Lenz, Lehmann, ...

For operation with Motorola systems, Uhlenbrock, Märklin

For operation with direct current

For operation with alternating current

Features:

• For track 0, I, IIm
• For all direct current motors
• For bell-type armature motors such as Faulhaber
• High clock frequency for quiet motor operation
• Short-circuit and overload protection
• Size: 68.5 x 28 x 12mm
• Shuttle train operation or INDUSI function via locomotive reed contact and track magnets
• Direction-dependent lighting, dimmable and switchable via f0
• 8 special function outputs
• Shunting gear (=½ speed) switchable via f3
• Starting/braking delay switchable via f4
• SUSI for connecting sound modules and other function extensions
• Connection of LGB sound modules possible
• 14, 27, 28, 128 speed steps, depending on data format
• Speed step table for 14 and 28 speed step mode
• Short and long addresses (1 - 9999)
• Adjustable acceleration/deceleration delay
• Automatic braking in signal sections using DCC-compliant brake signal or braking sections with DC voltage
• Minimum, maximum and average speed adjustable
• Programmable motor characteristic curve
• Main track programming with Motorola and DCC command stations
• Automatic detection of the operating mode or manual definition
• Programmable via any DCC or Motorola command station
• All special functions can also be switched with LGB control units
• Functions that would otherwise have to be laboriously reprogrammed during operation can simply be switched on and off using the function keys
• The programmed acceleration/braking delay can be switched on and off with f4, so that the vehicles can be controlled directly when shunting, for example
• The 'shunting gear' function, which can be switched via f3, is used to halve the speed over the entire control range so that very fine speed settings are possible
• The decoder supports register programming, direct CV programming and CV programming in paged mode and can therefore be programmed without restriction via all known DCC command stations. Programming is also possible without restriction with Märklin Motorola central units
• Max. Motor current: 3A, function outputs: 8x 1A, total load: 3A. The decoder is equipped with screw terminals

Specs:

• Gauge: H0
• Type: Accessories

Further links:

• Print View

CAUTION: Not suitable for children under 3 years. Danger of swallowing! Age recommendation from 14 years.